Moje Auto Virage Jumper cables

Moje Auto Virage Jumper cables - start your car using cables

Jumper cables Moje Auto Turn allow you to start the engine in passenger cars and delivery vans (depending on the model) with a discharged battery, using electricity taken from the battery of another vehicle. On offer Moje Auto Virage comes with cables of various power and length. Be sure to choose a model that is suitable for your engine. Also remember to connect the cables in the correct order. Car won't start? Jumper cables will come in handy Moje Auto Virage!

Jumper cables that are worth having in your car

Has your car not started in the morning?
Have you ever been unable to start your car while on a trip?
Do you want to be well prepared for the coming winter?

Jumper cables are necessary car accessories!

 Jumper cables Moje Auto Virage is available in 3 variants:

• Jumper cables 200 - 2 m. Length: 2 m. Designed for passenger cars. For starting engines with a maximum capacity of 1500 cm³.
• Jumper cables 400 - 2,5 metres. Length: 2,5 m. Designed for passenger cars. For starting engines with a maximum capacity of 2500 cm³.  
• Jumper cables 600 - 4 metres. Length: 4 m. Designed for passenger cars and delivery vans. For starting engines with a maximum capacity of 3000 cm³.

 Instructions for use

1. Position the vehicles so that they do not touch each other.
2. Turn off all power consumers.
3. The gear levers in both vehicles should be in the neutral position.
4. Connect the red terminal to the positive (+) terminals on both batteries (first to the starting vehicle's battery, then to the auxiliary battery).
5. Connect the black clamp to the negative (-) terminals on both batteries (first the auxiliary battery, then the starter battery).
6. Check that none of the cables touch any moving engine parts.
7. Start the vehicle with a dead battery. Do not use the cables for more than 10-15 seconds to start the engine.
8. Wait approximately 1 minute and try again. If starting has failed, there may be mechanical or electrical damage to the engine.
9. After a successful start, with the engines running, remove the terminals by reversing the procedure by removing the negative (-) terminal first.

Find out more about starting the car with cables!

The parameters of the jumper cables must be proportional to the amount of current drawn by the battery starter. The insulation of the wires must not be damaged.

Check how to prevent battery discharge!